1939 3rd Shift jobs in Hatboro,PA

Maintenance Mechanic - 3rd Shift

WestRock

Trenton, NJ 08618

Must be educationally certified through a tech or trade school beyond High School
Must be highly safety conscious.
Proven experience in the electrical/electronics, mechanical, hydraulic and pneumatic fields are required and the ability to demonstrate high proficiency in these areas.
A thorough knowledge of electrical/ electronic components and equipment including the use of special instruments for diagnostic purposes.
Willing to work any shift and overtime as required.
Computer experience/operation and PLC programming are necessary.
High degree of precision working with minimum tolerances required.
Ability to climb in overhead structures, to work beneath machines and in close quarters performing analysis and repair work.
Must be willing to obtain High Pressure Black Seal boiler operators license after probationary period
Candidates are required to undergo a drug screening after receiving a conditional job offer, but before starting employment.

Adecco

Quakertown, PA 18951

1st Shift – Monday to Friday, 7:00 AM to 3:00 PM
Pay: $22/hour
Location: Quakertown, PA
Previous experience in manufacturing, inspection, or quality control preferred
Ability to follow detailed instructions and SOPs
Comfortable working with microscopes or precision inspection tools
Strong attention to detail and documentation accuracy
Ability to work in a regulated manufacturing environment
Follow GMP/QSR requirements and maintain safety and gowning procedures
Enter job quantities and labor time into ERP systems
Inspect and measure products visually and using microscopes to record characteristics such as Ends per Inch (EPI), Picks per Inch (PPI), width, diameter, and thickness
Detect defects or contamination following work instructions, SOPs, and internal standards
Accurately record and communicate test and inspection results
Collect and document data to identify trends and support process improvements
Operate testing equipment including optical comparators, microscopes, hot knife equipment, and scanning electron microscopy (SEM)
Pack products for transfer to final inspection and packaging
Perform product scouring (washing) to remove contamination and spin finishes according to specifications
Heat set products to secure construction in final form
Cut products manually or with laser cutting equipment as required
Perform additional component processes such as sewing, skeining, coiling, kitting, and heat pressing
GMP/QSR requirements