339 Computer Technician jobs in Troy,SC

Quality Inspector I-1st Shift (G2 Location)

Eaton Aerospace

Greenwood, SC 29646

High school diploma or GED equivalent from an accredited institution.
One year of manufacturing experience
Eaton will not consider applicants for employment immigration sponsorship or support for this position. This means that Eaton will not support any CPT, OPT, or STEM OPT plans, F-1 to H-1B cap registration, O-1, E-3, TN status, I-485 job portability, etc.
No relocation benefit is being offered for this position. Only candidates within a 50-mile radius of Greenwood, SC will be considered. Active-Duty Military Service member candidates are exempt from the geographical area limitation.

West Fraser

Greenwood, SC 29646

GED or better
Minimal sitting
Occasional repetitive hand movements.
Frequent bending, walking,
Occasional twisting, climbing, stooping, kneeling
Occasional crawling or squatting
Sweeping/shoveling
Bending, pushing, lifting (up to 50 lbs)
Wood dust below the PEL
Occasional skin exposure to oil/grease
Temperature extremes (the work area is typically inside but not centrally heated or cooled. A local heater/ fan is provided)
Noise –hearing protection is required.
>1%: Cramped positions
65 - 85%: Standing
5% Sitting
65 - 80% Walking
5% Climbing (stairs/ladders)
35 - 45% Extended reach forward or overhead, push/pull/twist, grasp/handle, bend/stoop/squat,
5% fine hand dexterity,
5-15% repetitive motion operating a control console
5-15 pounds: Frequent
16-30 lbs: Moderate
31-45 lbs: Occasional
Greater than 46 lbs.: Minimal
There may be some heavy lifting requirements on occasions.
Frequent pushing, pulling,