749 Controller jobs in Aiken,SC

Associates degree in mechanical, electrical, or industrial maintenance and 5 years of machining maintenance technician experience in a heavy-duty manufacturing environment; or completion of apprenticeship or training program and 7 years of machining maintenance technician experience in a heavy-duty manufacturing environment.
This position is scheduled for the Off-Shift which starts at 8:00 PM and ends at 6:30AM, Sunday night through Thursday morning.
A shift premium will be added to the hourly rate.
Additional hours/days worked are eligible for overtime pay.
Applicants must be authorized to work for any employer in the U.S without sponsorship. We are unable to sponsor or take over sponsorship of an employment Visa at this time.

Operating Apprentice 1

West Fraser

Johnston, SC 29832

GED or better
Minimal sitting
Occasional repetitive hand movements.
Frequent bending, walking,
Occasional twisting, climbing, stooping, kneeling
Occasional crawling or squatting
Sweeping/shoveling
Bending, pushing, lifting (up to 50 lbs)
Wood dust below the PEL
Occasional skin exposure to oil/grease
Temperature extremes (the work area is typically inside but not centrally heated or cooled. A local heater/ fan is provided)
Noise –hearing protection is required.
>1%: Cramped positions
65 - 85%: Standing
5% Sitting
65 - 80% Walking
5% Climbing (stairs/ladders)
35 - 45% Extended reach forward or overhead, push/pull/twist, grasp/handle, bend/stoop/squat,
5% fine hand dexterity,
5-15% repetitive motion operating a control console
5-15 pounds: Frequent
16-30 lbs: Moderate
31-45 lbs: Occasional
Greater than 46 lbs.: Minimal
There may be some heavy lifting requirements on occasions.
Frequent pushing, pulling,