779 Electrical Engineer Science jobs in Albuquerque,NM

New, Posted 15 hours ago

Apply Directly

Sr. Project Engineer

MasTec Industrial

Albuquerque, NM 87101

$130,000-$160,000/yr

ResumeLibrary

Process Engineer

EV Group

Rio Rancho, NM 87124

Apply Directly

Electronics Engineer III

National Radio Astronomy Observatory

Albuquerque, NM 87101

HybridHealth InsurancePaid Time OffRetirement Benefit

Bachelor of Science in Electrical Engineering, Applied Physics, or a closely related field.
The starting salary/hourly rate of this position is between $99,822-$120,837.
Observatory employees must be authorized to work in the United States.
The Observatory presently cannot sponsor H-1B Visas for this position.
Post-offer, pre-employment/pre-placement drug screen must be successfully passed.
May occasionally be required to work outdoors or climb on antenna to heights greater than 40 feet above the ground.
May be required to travel domestically and internationally by air carrier and to travel by car between NRAO sites.
Experience in design, manufacture, and/or maintenance and repair of receiver systems, microwave antennas and feeds, local oscillators, and microwave/RF mixers and filters (minimum of three years).
Use of various types of electronics test equipment and familiarity with automated test setups to support general test and measurement.

SmartExplore AI is experimental.

New, Posted 1 day ago

Measurement Engineer - Gas Utilities (I/II/III)

TECO Energy

Albuquerque, NM 87101

No Experience

Apply Directly

Sr. Power Electronics Engineer

Raytheon

Albuquerque, NM 87121

OnsiteFlexible ScheduleHealth InsurancePaid Time OffRetirement Benefit

Active and transferable U.S. government issued security clearance is required prior to start date
U.S. citizenship is required, as only U.S. citizens are eligible for a security clearance
Security Clearance Type: DoD Clearance: Secret
Ability to obtain INTERIM U.S. government issued security clearance is required prior to start date
Typically requires a degree in Science, Technology, Engineering or Mathematics (STEM) and a minimum of 5 years of prior relevant experience or an Advanced Degree in a related field and minimum 3 years experience
Experience with any of the following: Power, analog, digital, and / or mixed signal circuit design or analysis and / or digital signal processing
Experience with analog laboratory equipment such as waveform generators, oscilloscopes, spectrum analyzers, and/or network analyzers
Experience with simulation software for circuit analysis or modeling
Experience leading Root-Cause Corrective Action investigations
Experience leading electrical engineering design
Experience with any of the following tools: Mentor Graphics Designer, PSPICE, System Vision, MATLAB, Mathcad, IDL, Computer Simulation Technologies (CST), Microwave Design Studio, High Frequency Structure Simulator (HFSS), Advanced Design System (ADS), SABER RD, SIMPLIS, or xDX Designer
Design and/or Analysis experience with analog electronics design, including at least one of the following: Power supply topologies (buck, boost, buck-boost), FETs/BJTs, op-amp, high/low/band pass filters, clock/data termination, and comparator circuits
Experience with subsystems integration and test, problem investigation, Statistical Process Control (SPC) methods in achieving production yield improvements, technical writing, formal presentation, and implementing Engineering Change Notices
Experience leading or executing Electronics CAD layouts for printed wiring or circuit boards
Self-starter who's capable of working independently as well as with a small technical team. Providing technical oversight and direction, cost estimation, tracking & reporting, coordination, preparation of detailed technical team reports, and proposal support
Demonstrated ability to lead teams to achieve schedule, budget and technical commitments
Experience with project management tools such as Earned Value and/or Agile Execution
Proposal development experience